Bud Booster Strip Kit RED, IR, Both, or UV LEDs w/Heatsink / Driver Grow Light

Description

WHEN IT COMES TO GROW LIGHTING,
THE BEST OPTION AVAILABLE IS STRIPS
1) COVERAGE - make it any size/shape you want/even side lighting is possible
2) CANOPY PENETRATION - more leds spread out gets deeper into canopy
3) VERSATILITY - add on or reconfigure any time you want
We at GrowDaddyLEDs.com are committed to helping you
set up your grow with the largest selection of strips around.
If you purchase these with the assembly option, the single strip kits are PLUG N PLAY - the 2 strip kit will need the power cord on one connected to a wago style connector
WE NOW HAVE FOUR DIFFERENT BUD BOOSTER STRIPS INCLUDING AN ALL NEW UV BOOSTER STRIP:
660 STRIP HAS
:
48 - 660NM DEEP RED LEDs
730 STRIP HAS
:
48 - 730NM FAR RED(IR) LEDs
660/730 STRIP HAS
:
36 - 660nm Deep Red LEDs
12 - 730nm Far Red(IR) LEDs
UV STRIP HAS
:
24 - 385nm UV LEDs
24 - 400nm UV LEDs
Single Strip Kit Includes
:
1 - 48 LED BUD BOOSTER STRIP
1 - 40mm x 430mm Heatsink
Thermal tape pre-applied to strip for easy installation (strong and good thermal conductivity)
1 - Meanwell LPC-20-700 Driver
6 foot power cord with on/off switch
Assembly is optional
Two Strip Kit Includes
:
2
- 48 LED BUD Booster STRIPS
2 - 40mmx430mm heatsinks OR 1 - 40mmx900mm Heatsink by request
T
hermal tape pre-applied to strips for easy installation (strong and good thermal conductivity)
1 -
Meanwell LPC-35-1400 Drivers
1 - 6 foot power cord with on/off switch
Assembly is optional
Each Strip
:
30mm x 400mm(approximately 16"x1.2")
24V
24w max
900mA max
2 - DUAL CONNECTORS (easier to wire in series and/or parallel)
2oz RA Copper
These are kits with
30mmx400mm (approximately 1.2 inch x 16 inches) 48
LED Strips with heatsink(s), driver, 6ft power cord with on/off switch, and double sided thermally conductive tape pre-applied to the strip(s) so all you need to do is pull the release paper and press it onto the heatsink. Not only does it hold strong, it also helps transfer the heat from the board to the heatsink. The single strip kit includes a single Meanwell LPC-20-700 driver with screws to mount it.
The two strip kit includes a single Meanwell
LPC-35-1400
driver with screws to mount it.
I can also assemble them for you for an extra charge. Note: the two strip kit is available on one long or two regular heatsinks(the one with two will need wires from one to the other). If you want two separate lights, you will need to order 2 single kits.
Anything else in the pics is for reference and not included. It just shows you a little of what can be done with these strips. Only your imagination can stop you.
Check out my other listings for separate strips, different spectrums, mixed sets, sets with heatsink(s), blue booster boards, red booster boards, etc. If you need a different quantity, custom configuration, complete DIY kit for a custom light, just send me a message or give me a call. We always have DISCREET SHIPPING and this is a private listing, so your purchase will remain anonymous on eBay.
The item description tells what comes in the listing. Some photos are stock and may show things that aren't included.