Universal Systems SE ProBilt 12 Adhesive Melter

Description

UNIVERSAL SYSTEMS SE PROBILT
™
SERIES 12 HOT MELT ADHESIVE UNIT --- Compatible to
Mesa
™
6 - Series 3400 Hot Melt Adhesive Unit
10 YEAR TANK HEATER WARRANTY
Tank Capacity:
12 lbs (6L)
Melt Rate:
15 lbs/hr
Pump Rate:
75 lbs/hr at 3200 Centipoise
Operating Temperature Range:
100-425 F
Viscosity Range:
850-31,000 Centipoise
Temperature Control:
Solid State
Voltage:
208-240 VAC 50/60 HZ 10/30
Hose Capacity:
Minimum of 1 / Maximum of 4
Weight:
75 lbs
Unit Dimensions:
22.25 x 22.70 x 13.50 in.
The ProBilt 12 unit is manufactured utilizing high quality materials that have been proven to outlast our competitors. The tank reservoir is solid aluminum with a cast in heater and is coated with genuine Dupont Teflon. A pneumatic pump is used to push the adhesive out of the tank, into a distribution manifold, and through a filter the adhesive exits the unit through four ports where heated hoses are attached to distribute to gun applicators.
The melter is controlled by the AccuScan Control System Panel which controls and monitors temperature within +/- 1 degree. The control system uses resistance temperature detectors (RTD’s) to calculate and regulate the temperature of the tank, hoses and guns. Standard features included temperature setback, parent machine interlock functionality, external fault alarm interface, and a sequential start up routine that automatically powers up the system in a manner that optimizes the life of the unit and its components.
There are also safety features built into the ProBilt 12 unit that protect operators and require no additional setup or maintenance. The self-resetting thermal safety cut off activates if the temperature of the melter exceeds 450 degrees Fahrenheit and then resets when the temperature drops. The manifold pressure relief valve limits the amount of pressure the system can build up, and takes effect at approximately 1400 PSI.